LISTRONG LISTRONG

News Center

Share latest company information & industry trends

/
/
What should we do when the traverse unit of wire drawing machine is bad?

News Categories

Check Category

What should we do when the traverse unit of wire drawing machine is bad?

  • Categories:News
  • Time of issue:2021-05-20 13:30

(Summary description)When the traversing is bad, please check the traversing width, traversing motor, limit switch and traversing belt in time.

What should we do when the traverse unit of wire drawing machine is bad?

(Summary description)When the traversing is bad, please check the traversing width, traversing motor, limit switch and traversing belt in time.

  • Categories:News
  • Time of issue:2021-05-20 13:30
  • Views:
Information
1. The traverse width has not been adjusted properly
 
Solution: adjust the traverse width
 
2. Traversing motor failure
 
Solution: Check the traversing motor and connection wiring
 
3. Poor contact of limit switch
 
Solution: Replace the limit switch
 
4. The traversing belt slips
 
Solution: Clean and adjust the traversing belt 

Scan the QR code to read on your phone

Relevant Information
Share the latest developments of the company and industry exhibition information with you.
Related Products
A professional wire and cable production equipment manufacturer
CopyRight © 2021 LISTRONG Mechanical & Electrical Co., Ltd. All rights reserved.   苏ICP备2023022378号-2   Powered by:www.300.cn   IPv6 network supported
TOP