LISTRONG LISTRONG

News Center

Share latest company information & industry trends

/
/
What should we do if the wire drawing machine frequently breaks?

News Categories

Check Category

What should we do if the wire drawing machine frequently breaks?

  • Categories:News
  • Time of issue:2021-05-28 13:49

(Summary description)When the wire drawing machine is frequently broken, please check it in time to eliminate the fault and improve the production efficiency

What should we do if the wire drawing machine frequently breaks?

(Summary description)When the wire drawing machine is frequently broken, please check it in time to eliminate the fault and improve the production efficiency

  • Categories:News
  • Time of issue:2021-05-28 13:49
  • Views:
Information
1. There is a problem with the die configuration
 
Solution: Configure the die strictly according to the wire drawing machine reduction rate
 
2. The process speed is too fast
 
Solution: reduce wire drawing speed
 
3. Bad wire (irregular disconnection)
 
Solution: Replace the wire
 
4. Lubricating fluid has deteriorated
 
Solution: check and replace lubricating fluid
 
5. Capstan sticking line
 
Solution: Clean the capstan with alcohol
 
6. There are burrs around the take-up bobbin
 
Solution: sand the burrs of the take-up bobbin with sandpaper
 
7, the line is not smooth
 
Solution: adjust the pay-off position and choose a suitable pay-off method
 
8. The pay-off speed is too fast
 
Solution: increase the diameter of the inlet wire or reduce the speed of the outlet wire 
 

Scan the QR code to read on your phone

Relevant Information
Share the latest developments of the company and industry exhibition information with you.
Related Products
A professional wire and cable production equipment manufacturer
CopyRight © 2021 LISTRONG Mechanical & Electrical Co., Ltd. All rights reserved.   苏ICP备2023022378号-2   Powered by:www.300.cn   IPv6 network supported
TOP