LISTRONG LISTRONG

News Center

Share latest company information & industry trends

/
/
Causes and troubleshooting methods for over-twisting of bunching and stranding machine products

News Categories

Check Category

Causes and troubleshooting methods for over-twisting of bunching and stranding machine products

  • Categories:News
  • Time of issue:2021-09-16 09:49

(Summary description)Twist-shaped phenomenon appears in the finished product of bundled wire and twisted wire, under normal circumstances, it is caused by over-twisting.

Causes and troubleshooting methods for over-twisting of bunching and stranding machine products

(Summary description)Twist-shaped phenomenon appears in the finished product of bundled wire and twisted wire, under normal circumstances, it is caused by over-twisting.

  • Categories:News
  • Time of issue:2021-09-16 09:49
  • Views:
Information
Defects and scraps of bundles and strands, the main problems are over-twist, inner or outer single wire break, lack of strands, single wire or strand surface scratches, single wire back strands, single wire peeling, scars, brittle breaks, Arching, inclusions, excessive or wrong wire diameter, wrong stranding direction, serpentine, large stranding pitch, unqualified length, loose strands, disordered wiring and crushing, scratches, bruises , The DC resistance of the conductive core of the wire and cable is unqualified, etc. Among them, over-twisting refers to the twisting phenomenon in the twisting process.
Reasons for over-twisting of cable bundles and twisted wire products: First, the number of turns of the twisted wire on the traction wheel is not enough, generally less than 4 turns, the friction is too small and slips, resulting in excessive twisting. The second is that the tension of the take-up wire is loose or the take-up reel does not rotate, and the rotor is still rotating, resulting in excessive twisting.
Excessive twisting of cable bundles and stranded wire products: If the outer single wire has been severely deformed and the damage is serious, there is no possibility to repair it, and only cut it. If the single wire is not severely damaged, you can separate the rotating part of the equipment from the traction part, rotate it in the opposite direction of the twisting, and retract the partially twisted part, then repair the core by hand, and wind the excess single wire to On the take-up reel, unite the equipment and the rotating body. After the loose over-pressure line mold, press the line forcefully and manually repair it with the mold, so that the production can be restarted.
Keyword:

Scan the QR code to read on your phone

Relevant Information
Share the latest developments of the company and industry exhibition information with you.
Related Products
A professional wire and cable production equipment manufacturer
CopyRight © 2021 LISTRONG Mechanical & Electrical Co., Ltd. All rights reserved.   苏ICP备2023022378号-2   Powered by:www.300.cn   IPv6 network supported
TOP